Yamasuzihoncati?
Posted: Wed Aug 19, 2009 9:36 am
Sorry guys, I havn't remained true to the cause.
But, dammit, I just want this thing to go on and on and on...
So, another winter project is over
Yamaha fz750 headlight - untried, but will let you know
Clutch basket drive bearings
Gear change selector fork pivot repaired - behind magneto
Honda CBR600F3 front brake calipers -4 pot - home made bracket
FZR1000 front wheel and rotors - 120/60x17 - Diablo
Suzuki back wheel -150/60x17 - Diablo - modified back caliper bracket
Starter solenoid - Ford - hehe
Mikuni cv carbs, Dyanjet stage one kit with pod filters
Cylinders honed and new rings -(sorry J fiore - those rings just never liked my bike) - had to due to ring/piston damage
Front fork seals and dust caps
Dual airhorns - sick of deaf car drivers
Ducati Monster Mufflers -slightly modified -shhhhhhhhhhhhh don't tell Ministry of Transport (old 2 into 1 Conti was stuffed)
Made my own headers - 10 pieces of tube - nightmare to fit around side stand, centre stand,oil filter,oil drain, swing arm, fairings etc
But - I'm happy - a little crazy maybe
It may not be the same bike that rolled out of the factory but it looks good to me........
Roll on summer
Tony
But, dammit, I just want this thing to go on and on and on...
So, another winter project is over
Yamaha fz750 headlight - untried, but will let you know
Clutch basket drive bearings
Gear change selector fork pivot repaired - behind magneto
Honda CBR600F3 front brake calipers -4 pot - home made bracket
FZR1000 front wheel and rotors - 120/60x17 - Diablo
Suzuki back wheel -150/60x17 - Diablo - modified back caliper bracket
Starter solenoid - Ford - hehe
Mikuni cv carbs, Dyanjet stage one kit with pod filters
Cylinders honed and new rings -(sorry J fiore - those rings just never liked my bike) - had to due to ring/piston damage
Front fork seals and dust caps
Dual airhorns - sick of deaf car drivers
Ducati Monster Mufflers -slightly modified -shhhhhhhhhhhhh don't tell Ministry of Transport (old 2 into 1 Conti was stuffed)
Made my own headers - 10 pieces of tube - nightmare to fit around side stand, centre stand,oil filter,oil drain, swing arm, fairings etc
But - I'm happy - a little crazy maybe
It may not be the same bike that rolled out of the factory but it looks good to me........
Roll on summer
Tony